Application

Novibra type HA is available in 4 versions to suit the small and medium range of Novibra AV-mountings, as listed on table below. It also allows Novibra mountings to be retrofitted to existing installations where original spares are unobtainable.

Notes :

• For optimum solutions where close coupling tolerances are required, leave the mountings to settle for 24 hours before final alignment of the engine installation.
  
  
• For securing the boIt into the mounting, it is recommended to apply Loctite.
  
  
• For the dimensions HA 16/16 and 16/20 it is necessary to use a larger washer than nr 4 in the sketch, approx 30% of the diameter of the upper part of the cover.
  
  
• For mobile applications it is recommended to use a washer that has the same size as the diameter of the upper part of the cover for the corresponding RA, RAB and RAEM mount.
  
  
• The height adjuster HA can be used together with Novibra type M-mount. See description of M-mount.

FEATURES

Novibra type HA is a height adjuster made in corrosion protected steel. The steel is zinc plated and chromated according to DIN 50691/ISO 2081.

The height adjuster is supplied complete with washer and nut for the fastening to the mounting and two nuts and a lock washer for the engine foot fastening.

The HA height adjustment facilities precise coupling alignment for engine installations and boat building tolerances.